R3303-HP HSR6800 Routers IP Multicast Command Reference
29
[Sysname-vlan2] igmp-snooping special-query source-ip 10.1.1.1
Related commands
igmp-snooping enable
igmp-snooping static-group
Use igmp-snooping static-group to configure a port as a static member port of the specified multicast
group or the specified multicast source and group.
Use undo igmp-snooping static-group to restore the default.
Syntax
igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id
undo igmp-snooping static-group group-address [ source-ip source-address ] vlan vlan-id
Default
No ports are static member ports.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default command level
2: System level
Parameters
group-address: Specifies the address of the multicast group that the port joins as a static member port, in
the range of 224.0.1.0 to 239.255.255.255.
source-address: Specifies the address of the multicast source that the port joins as a static member port.
The value of this argument should be a valid unicast address or 0.0.0.0. A source IP address of 0.0.0.0
specifies all multicast sources.
vlan vlan-id: Specifies a VLAN. The value range for the vlan-id argument is 1 to 4094.
Usage guidelines
The source-ip source-address option in the command is meaningful only for IGMPv3 snooping. If
IGMPv2 snooping is running, the source-ip source-address option does not take effect although you can
include source-ip source-address in the command.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN.
In port group view, this command takes effect only on those ports in this port group that belong to the
specified VLAN.
Examples
# Configure GigabitEthernet 2/0/1 in VLAN 2 to be a static member port for the multicast source and
g r o u p (1.1.1.1, 23 2.1.1.1) .
<Sysname> system-view
[Sysname] igmp-snooping
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable