R3303-HP HSR6800 Routers IP Multicast Command Reference

30
[Sysname-vlan2] igmp-snooping version 3
[Sysname-vlan2] quit
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] igmp-snooping static-group 232.1.1.1 source-ip 1.1.1.1
vlan 2
igmp-snooping static-router-port
Use igmp-snooping static-router-port to configure a port as a static router port.
Use undo igmp-snooping static-router-port to restore the default.
Syntax
igmp-snooping static-router-port vlan vlan-id
undo igmp-snooping static-router-port vlan vlan-id
Default
No ports are static router ports.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view, port group view
Default command level
2: System level
Parameters
vlan vlan-id: Specifies a VLAN. The value range for the vlan-id argument is 1 to 4094.
Usage guidelines
For a router that supports both IGMP snooping and IGMP and is installed with the SAP module, this
command takes effect on IGMP snooping-enabled VLANs and VLANs with IGMP-enabled VLAN
interfaces.
This command does not take effect on a sub-VLAN of a multicast VLAN.
In Layer 2 Ethernet interface view or Layer 2 aggregate interface view, this command takes effect only if
the interface belongs to the specified VLAN. In port group view, this command takes effect only on those
ports in this port group that belong to the specified VLAN.
Examples
# Configure GigabitEthernet2/0/1 in VLAN 2 as a static router port.
<Sysname> system-view
[Sysname] interface gigabitethernet 2/0/1
[Sysname-GigabitEthernet2/0/1] igmp-snooping static-router-port vlan 2
Related commands
subvlan
igmp-snooping version
Use igmp-snooping version to specify the IGMP snooping version.
Use undo igmp-snooping version to restore the default.