R3303-HP HSR6800 Routers IP Multicast Command Reference

426
route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters.
Using a routing policy, you can configure the preferences for the routes that match the policy. The routes
that do not match the policy use the default preferences.
Usage guidelines
The greater the preference value is, the lower the preference is.
Examples
# Configure preferences for IPv6 multicast EBGP, IPv6 multicast IBGP, and local IPv6 MBGP routes as 20,
20, and 200.
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] preference 20 20 200
reflect between-clients (IPv6 MBGP address family view)
Use reflect between-clients to enable route reflection between clients.
Use undo reflect between-clients to disable this function.
Syntax
reflect between-clients
undo reflect between-clients
Default
Route reflection between clients is enabled.
Views
IPv6 MBGP address family view
Default command level
2: System level
Usage guidelines
After a route reflector is configured, it reflects the routes of a client to the other clients. If the clients of a
route reflector are fully meshed, you need to disable route reflection between clients to reduce routing
costs.
Examples
# Enable route reflection between clients
<Sysname> system-view
[Sysname]bgp 100
[Sysname-bgp] ipv6-family multicast
[Sysname-bgp-af-ipv6-mul] reflect between-clients
Related commands
• peer reflect-client
• reflector cluster-id