R3303-HP HSR6800 Routers IP Multicast Command Reference

440
Use undo port to remove the specified ports from the current multicast VLAN.
Syntax
port interface-list
undo port { all | interface-list }
Default
A multicast VLAN has no ports.
Views
Multicast VLAN view
Default command level
2: System level
Parameters
interface-list: Specifies a port in the form of interface-type interface-number, or a port range in the form
of interface-type start-interface-number to interface-type end-interface-number, where the end interface
number must be greater than the start interface number.
all: Specifies all the ports in the current multicast VLAN.
Usage guidelines
A port can belong to only one multicast VLAN.
You can assign Ethernet ports and Layer 2 aggregate interfaces as multicast VLAN ports.
Examples
# Assign ports GigabitEthernet 2/0/1 through GigabitEthernet 2/0/5 to multicast VLAN 100.
<Sysname> system-view
[Sysname] multicast-vlan 100
[Sysname-mvlan-100] port gigabitethernet 2/0/1 to gigabitethernet 2/0/5
port multicast-vlan
Use port multicast-vlan to assign the current port to the specified multicast VLAN.
Use undo port multicast-vlan to restore the default.
Syntax
port multicast-vlan vlan-id
undo port multicast-vlan
Default
A port does not belong to any multicast VLAN.
Views
Ethernet interface view, Layer 2 aggregate interface view, port group view.
Default command level
2: System level