R3303-HP HSR6800 Routers IP Multicast Configuration Guide

91
3. Enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP and IGMP SSM
mapping on the host-side interface:
# Enable IP multicast routing on Router D, enable PIM-SM on each interface and enable IGMPv3
and IGMP SSM mapping on GigabitEthernet 2/1/1.
<RouterD> system-view
[RouterD] multicast routing-enable
[RouterD] interface gigabitethernet 2/1/1
[RouterD-GigabitEthernet2/1/1] igmp enable
[RouterD-GigabitEthernet2/1/1] igmp version 3
[RouterD-GigabitEthernet2/1/1] igmp ssm-mapping enable
[RouterD-GigabitEthernet2/1/1] pim sm
[RouterD-GigabitEthernet2/1/1] quit
[RouterD] interface gigabitethernet 2/1/2
[RouterD-GigabitEthernet2/1/2] pim sm
[RouterD-GigabitEthernet2/1/2] quit
[RouterD] interface gigabitethernet 2/1/3
[RouterD-GigabitEthernet2/1/3] pim sm
[RouterD-GigabitEthernet2/1/3] quit
# Enable IP multicast routing on Router A, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] pim sm
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface gigabitethernet 2/1/2
[RouterA-GigabitEthernet2/1/2] pim sm
[RouterA-GigabitEthernet2/1/2] quit
[RouterA] interface gigabitethernet 2/1/3
[RouterA-GigabitEthernet2/1/3] pim sm
[RouterA-GigabitEthernet2/1/3] quit
# Configure Router B and Router C in the same way as you configure Router A.
4. Configure C-BSR and C-RP interfaces on Router D.
[RouterD] pim
[RouterD-pim] c-bsr gigabitethernet 2/1/3
[RouterD-pim] c-rp gigabitethernet 2/1/3
[RouterD-pim] quit
5. Configure the SSM group range:
# Configure the SSM group range 232.1.1.0/24 on Router D.
[RouterD] acl number 2000
[RouterD-acl-basic-2000] rule permit source 232.1.1.0 0.0.0.255
[RouterD-acl-basic-2000] quit
[RouterD] pim
[RouterD-pim] ssm-policy 2000
[RouterD-pim] quit
# Configure Router A, Router B, and Router C in the same way as you configure Router D. (Details
not shown.)
6. Configure IGMP SSM mappings on Router D.