R3303-HP HSR6800 Routers IP Multicast Configuration Guide

127
• Determine the C-RP priority and the ACL that defines the range of multicast groups to be served by
each C-RP.
• Determine the legal C-RP address range and the ACL that defines the range of multicast groups to
be served.
• Determine the C-RP-Adv interval.
• Determine the C-RP timeout timer.
• Determine the C-BSR priority.
• Determine the hash mask length.
• Determine the ACL defining the legal BSR address range.
• Determine the BS period.
• Determine the BS timeout timer.
Enabling PIM-SM
Because BIDIR-PIM is implemented on the basis of PIM-SM, you must enable PIM-SM before enabling
BIDIR-PIM. To deploy a BIDIR-PIM domain, enable PIM-SM on all non-border interfaces of the domain.
IMPORTANT:
A
ll interfaces on a device must be enabled with the same PIM mode.
Enabling PIM-SM globally for the public network
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IP multicast routing.
multicast routing-enable Disabled by default.
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable PIM-SM.
pim sm Disabled by default.
Enabling PIM-SM for a VPN instance
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create a VPN instance and
enter VPN instance view.
ip vpn-instance vpn-instance-name
N/A
For more information about this
command, see MPLS Command
Reference.
3. Configure an RD for the VPN
instance.
route-distinguisher
route-distinguisher
Not configured by default.
For more information about this
command, see MPLS Command
Reference.
4. Enable IP multicast routing.
multicast routing-enable Disabled by default.