R3303-HP HSR6800 Routers IP Multicast Configuration Guide

176
MSDP configuration task list
Task Remarks
Configuring basic MSDP
functions
Enabling MSDP Required.
Creating an MSDP peer connection Required.
Configuring a static RPF peer Optional.
Configuring an MSDP peer
connection
Configuring MSDP peer description Optional.
Configuring an MSDP mesh group Optional.
Configuring MSDP peer connection control Optional.
Configuring SA message
related parameters
Configuring SA message content Optional.
Configuring SA request messages Optional.
Configuring SA message filtering rules Optional.
Configuring the SA cache mechanism Optional.
Configuring basic MSDP functions
All the configuration tasks should be performed on RPs in PIM-SM domains, and each of these RPs acts
as an MSDP peer.
Configuration prerequisites
Before you configure basic MSDP functions, complete the following tasks:
• Configure any unicast routing protocol so that all devices in the domain are interoperable at the
network layer.
• Configure PIM-SM to enable intra-domain multicast forwarding.
• Determine the IP addresses of MSDP peers.
• Determine the address prefix list for an RP address filtering policy.
Enabling MSDP
This section describes how to enable MSDP.
Enabling MSDP globally for the public network
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IP multicast routing.
multicast routing-enable Disabled by default.
3. Enable MSDP and enter
public network MSDP view.
msdp Disabled by default.