R3303-HP HSR6800 Routers IP Multicast Configuration Guide

184
PIM-SM Inter-domain multicast configuration
Network requirements
As shown in Figure 54, the network has two OSPF ASs: AS 100 and AS 200. BGP runs between the two
ASs.
PIM-SM 1 belongs to AS 100, and PIM-SM 2 and PIM-SM 3 belong to AS 200. Each PIM-SM domain
has at least one multicast source or receiver.
Configure Loopback 0 as the C-BSR and C-RP of the related PIM-SM domain on Router B, Router C, and
Router E.
Set up MSDP peering relationships through eBGP between the RPs of the PIM-SM domains to share
multicast source information among the PIM-SM domains.
Figure 54 Network diagram
Device Interface IP address Device Interface IP address
Router A GE2/1/1 10.110.1.2/24 Router D GE2/1/1 10.110.4.2/24
GE2/1/2 10.110.2.1/24 GE2/1/2 10.110.5.1/24
GE2/1/3 10.110.3.1/24 Router E GE2/1/1 10.110.6.1/24
Router B GE2/1/1 10.110.1.1/24 S3/1/0 192.168.3.2/24
POS5/1/0 192.168.1.1/24 Loop0 3.3.3.3/32
Loop0 1.1.1.1/32 Router F GE2/1/1 10.110.6.2/24
Router C GE2/1/1 10.110.4.1/24 GE2/1/2 10.110.7.1/24
S3/1/0 192.168.3.1/24 Source 1 — 10.110.2.100/24
POS5/1/0 192.168.1.2/24 Source 2 — 10.110.5.100/24
Loop0 2.2.2.2/32
GE2/1/1
GE2/1
/1
GE2/1/3
GE2/1/2
GE2/1
/2