R3303-HP HSR6800 Routers IP Multicast Configuration Guide

194
[RouterB-Serial3/1/0] pim sm
[RouterB-Serial3/1/0] quit
[RouterB] interface pos 5/1/0
[RouterB-Pos5/1/0] pim sm
[RouterB-Pos5/1/0] quit
[RouterB] interface loopback 0
[RouterB-LoopBack0] pim sm
[RouterB-LoopBack0] quit
[RouterB] interface loopback 10
[RouterB-LoopBack10] pim sm
[RouterB-LoopBack10] quit
[RouterB] interface loopback 20
[RouterB-LoopBack20] pim sm
[RouterB-LoopBack20] quit
# Enable IP multicast routing, PIM-SM, and IGMP on Router A, Router C, Router D, and Router E in
the same way. (Details not shown.)
4. Configure C-BSRs and C-RPs:
# Configure Loopback 10 as a C-BSR and configure Loopback 20 as a C-RP on Router B.
[RouterB] pim
[RouterB-pim] c-bsr loopback 10
[RouterB-pim] c-rp loopback 20
[RouterB-pim] quit
# Configure the C-BSR and the C-RP on Router D in the same way. (Details not shown.)
5. Configure MSDP peers:
# Configure an MSDP peer on Loopback 0 of Router B.
[RouterB] msdp
[RouterB-msdp] originating-rp loopback 0
[RouterB-msdp] peer 2.2.2.2 connect-interface loopback 0
[RouterB-msdp] quit
# Configure an MSDP peer on Loopback 0 of Router D.
[RouterD] msdp
[RouterD-msdp] originating-rp loopback 0
[RouterD-msdp] peer 1.1.1.1 connect-interface loopback 0
[RouterD-msdp] quit
6. Verify the configuration:
# Display brief information about MSDP peers on Router B.
[RouterB] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured Up Listen Connect Shutdown Down
1 1 0 0 0 0
Peer's Address State Up/Down time AS SA Count Reset Count
2.2.2.2 Up 00:10:17 ? 0 0
# Display brief information about MSDP peers on Router D.
[RouterD] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net