R3303-HP HSR6800 Routers IP Multicast Configuration Guide

245
Task Command Remarks
Display information about BGP
MDT peer groups.
display bgp mdt group [ group-name ] [ |
{ begin | exclude | include }
regular-expression ]
Available in any view.
Display information about BGP
MDT peers.
display bgp mdt peer [ [ ip-address ] verbose ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display BGP MDT routing
information.
display bgp mdt { all | route-distinguisher
route-distinguisher } routing-table [ ip-address
[ mask | mask-length ] ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Reset BGP MDT connections.
reset bgp mdt { as-number | ip-address | all |
external | group group-name | internal }
Available in user
view.
Multicast VPN configuration examples
This section provides examples of configuring multicast VPN.
Single-AS MD VPN configuration example
Network requirements
Item Network re
q
uirements
Multicast sources and receivers
• In VPN a, S 1 is a multicast source, and R 1, R 2 and R 3 are receivers.
• In VPN b, S 2 is a multicast source, and R 4 is a receiver.
• For VPN a, the share-group address is 239.1.1.1, and the range of its
switch-group-pool addresses is 225.2.2.0 to 225.2.2.15.
• For VPN b, the share-group address is 239.2.2.2, and the range of its
switch-group-pool addresses is 225.4.4.0 to 225.4.4.15.
PE interfaces and VPN
instances they belong to
• PE 1—GigabitEthernet 2/1/2 and GigabitEthernet 2/1/3 belong to
VPN instance a. GigabitEthernet 2/1/1 and Loopback 1 belong to the
public network.
• PE 2—GigabitEthernet 2/1/2 belongs to VPN instance b.
GigabitEthernet 2/1/3 belongs to VPN instance a. GigabitEthernet
2/1/1 and Loopback 1 belong to the public network.
• PE 3—GigabitEthernet 2/1/2 belongs to VPN instance a.
GigabitEthernet 2/1/3 and Loopback 2 belongs to VPN instance b.
GigabitEthernet 2/1/1 and Loopback 1 belong to the public network.
Unicast routing protocols and
MPLS
• Configure OSPF on the public network, and configure RIP between the PE
devices and the CE devices.
• Establish BGP peer connections between PE 1, PE 2 and PE 3 on their
respective Loopback 1 and exchange all VPN routes between them.
• Configure MPLS on the public network.