R3303-HP HSR6800 Routers IP Multicast Configuration Guide

278
Step Command Remarks
1. Enter system view.
system-view N/A
2. Configure a static multicast
MAC address entry.
mac-address multicast
mac-address interface interface-list
vlan vlan-id
No static multicast MAC address
entries existing by default.
Configuring an IPv6 static multicast MAC address entry in interface view
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter Ethernet interface/Layer
2 aggregate interface view or
port group view.
• Enter Ethernet interface/Layer 2
aggregate interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
In Ethernet interface view or Layer
2 aggregate interface view, the
configuration is effective on only
the current interface. In port group
view, the configuration is effective
on all ports in the port group.
3. Configure a static multicast
MAC address entry.
mac-address multicast
mac-address vlan vlan-id
No static multicast MAC address
entries exist by default.
For more information about the
mac-address multicast command,
see IP Multicast Command
Reference.
Displaying and maintaining IPv6 multicast routing
and forwarding
CAUTION:
The reset commands might cause IPv6 multicast transmission failures.
To display and maintain IPv6 multicast routing and forwarding:
Task Command Remarks
Display IPv6 multicast
boundary information.
display multicast ipv6 boundary { group
[ ipv6-group-address [ prefix-length ] ] | scope
[ scope-id ] } [ interface interface-type
interface-number ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.