R3303-HP HSR6800 Routers IP Multicast Configuration Guide

294
• Determine the IPv6 multicast group address and IPv6 multicast source address for static group
member configuration.
• Determine the ACL rule for IPv6 multicast group filtering.
• Determine the maximum number of IPv6 multicast groups that an interface can join.
Enabling MLD
Enable MLD on the interface on which IPv6 multicast group memberships will be created and
maintained.
To enable MLD:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IPv6 multicast
routing.
multicast ipv6 routing-enable Disable by default.
3. Enter interface view.
interface interface-type interface-number N/A
4. Enable MLD.
mld enable Disabled by default.
Configuring the MLD version
Because MLD message types and formats vary with MLD versions, the same MLD version should be
configured for all routers on the same subnet before MLD can operate correctly.
Configuring an MLD version globally
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter MLD view.
mld N/A
3. Configure an MLD version
globally.
version version-number MLDv1 by default.
Configuring an MLD version on an interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an MLD version on
the interface.
mld version version-number MLDv1 by default.