R3303-HP HSR6800 Routers IP Multicast Configuration Guide

342
Perform the following configuration on routers that might become receiver-side DRs and on C-RP routers.
To configure switchover to SPT:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
pim ipv6 N/A
3. Configure the criteria for
triggering a switchover to SPT.
spt-switch-threshold infinity
[ group-policy acl6-number [ order
order-value ] ]
Optional.
By default, the device switches to
the SPT immediately after it
receives the first IPv6 multicast
packet from the RPT.
Configuring IPv6 BIDIR-PIM
This section describes how to configure IPv6 BIDIR-PIM.
IPv6 BIDIR-PIM configuration task list
Task Remarks
Enabling IPv6 PIM-SM Required.
Enabling IPv6 BIDIR-PIM Required.
Configuring an RP
Configuring a static RP
Required.
Use any method.
Configuring a C-RP
Enabling embedded RP
Configuring C-RP timers globally Optional.
Configuring a BSR
Configuring a C-BSR Required.
Configuring an IPv6 BIDIR-PIM domain border Optional.
Configuring C-BSR parameters globally Optional.
Configuring C-BSR timers Optional.
Disabling BSM semantic fragmentation Optional.
Configuring IPv6 administrative
scoping
Enabling IPv6 administrative scoping Optional.
Configuring an IPv6 admin-scoped zone
boundary
Optional.
Configuring C-BSRs for each admin-scoped zone Optional.
Configuring common IPv6 PIM features Optional.
Configuration prerequisites
Before you configure IPv6 BIDIR-PIM, complete the following tasks: