R3303-HP HSR6800 Routers IP Multicast Configuration Guide

343
• Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain can communicate with each other at Layer 3.
• Determine the IPv6 address of a static RP and the IPv6 ACL that defines the range of IPv6 multicast
groups to be served by the static RP.
• Determine the C-RP priority and the IPv6 ACL that defines the range of IPv6 multicast groups to be
served by each C-RP.
• Determine the legal C-RP address range and the IPv6 ACL that defines the range of IPv6 multicast
groups to be served.
• Determine the C-RP-Adv interval.
• Determine the C-RP timeout timer.
• Determine the C-BSR priority.
• Determine the hash mask length.
• Determine the IPv6 ACL defining the legal BSR address range.
• Determine the BS period.
• Determine the BS timeout timer.
Enabling IPv6 PIM-SM
You must enable IPv6 PIM-SM before enabling IPv6 BIDIR-PIM because IPv6 BIDIR-PIM is implemented on
the basis of IPv6 PIM-SM. To deploy an IPv6 BIDIR-PIM domain, enable IPv6 PIM-SM on all non-border
interfaces of the domain.
IMPORTANT:
A
ll interfaces on a device must operate in the same IPv6 PIM mode.
To enable IPv6 PIM-SM:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable IPv6 multicast routing.
multicast ipv6 routing-enable Disabled by default.
3. Enter interface view.
interface interface-type
interface-number
N/A
4. Enable IPv6 PIM-SM.
pim ipv6 sm Disabled by default.
Enabling IPv6 BIDIR-PIM
Perform this configuration on all routers in the IPv6 BIDIR-PIM domain.
To enable IPv6 BIDIR-PIM:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
pim ipv6 N/A
3. Enable IPv6 BIDIR-PIM.
bidir-pim enable Disabled by default.