R3303-HP HSR6800 Routers IP Multicast Configuration Guide

347
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
pim ipv6 N/A
3. Configure an interface as a
C-BSR.
c-bsr ipv6-address [ hash-length
[ priority ] ]
No C-BSRs are configured by
default.
4. Configure a legal BSR
address range.
bsr-policy acl6-number
Optional.
No restrictions on BSR address
range by default.
Configuring an IPv6 BIDIR-PIM domain border
As the administrative core of an IPv6 BIDIR-PIM domain, the BSR sends the collected RP-Set information
in the form of bootstrap messages to all routers in the IPv6 BIDIR-PIM domain.
An IPv6 BIDIR-PIM domain border is a bootstrap message boundary. Each BSR has its specific service
scope. A number of IPv6 BIDIR-PIM domain border interfaces partition a network into different IPv6
BIDIR-PIM domains. Bootstrap messages cannot cross a domain border in either direction.
Perform the following configuration on routers that you want to configure as the IPv6 BIDIR-PIM domain
border.
To configure an IPv6 BIDIR-PIM domain border:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Configure an IPv6 BIDIR-PIM
domain border.
pim ipv6 bsr-boundary
By default, no IPv6 BIDIR-PIM
domain border is configured.
Configuring C-BSR parameters globally
In each IPv6 BIDIR-PIM domain, a unique BSR is elected from C-BSRs. The C-RPs in the IPv6 BIDIR-PIM
domain send advertisement messages to the BSR. The BSR summarizes the advertisement messages to
form an RP-set and advertises it to all routers in the IPv6 BIDIR-PIM domain. All the routers use the same
hash algorithm to get the RP address corresponding to specific multicast groups.
Perform the following configuration on C-BSR routers.
To configure C-BSR parameters globally:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter IPv6 PIM view.
pim ipv6 N/A
3. Configure the hash mask
length.
c-bsr hash-length hash-length
Optional.
126 by default.
4. Configure the C-BSR priority.
c-bsr priority priority
Optional.
64 by default.