R3303-HP HSR6800 Routers IP Multicast Configuration Guide

27
Ste
p
Command Remarks
2. Enter VLAN view.
vlan vlan-id N/A
3. Configure the source IP
address for IGMP general
queries.
igmp-snooping general-query source-ip
{ ip-address | current-interface }
0.0.0.0 by default.
4. Configure the source IP
address for IGMP
group-specific queries.
igmp-snooping special-query source-ip
{ ip-address | current-interface }
0.0.0.0 by default.
Configuring IGMP snooping proxying
This section describes how to configure IGMP snooping proxying.
Configuration prerequisites
Before you configure IGMP snooping proxying in a VLAN, complete the following tasks:
• Enable IGMP snooping in the VLAN.
• Determine the source IP address for the IGMP reports sent by the proxy.
• Determine the source IP address for the IGMP leave messages sent by the proxy.
Enabling IGMP snooping proxying
The IGMP snooping proxying function works on a per-VLAN basis. After you enable the function in a
VLAN, the router works as the IGMP snooping proxy for the downstream hosts and upstream router in the
VLAN.
To enable IGMP snooping proxying in a VLAN:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter VLAN view.
vlan vlan-id N/A
3. Enable IGMP snooping
proxying in the VLAN.
igmp-snooping proxying enable Disabled by default.
Configuring the source IP addresses for the IGMP messages
sent by the proxy
You can set the source IP addresses for the IGMP reports and leave messages that the IGMP snooping
proxy sends on behalf of its attached hosts.
To configure the source IP addresses for the IGMP messages sent by the proxy in a VLAN:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A