R3303-HP HSR6800 Routers IP Multicast Configuration Guide

380
Figure 104 Network diagram
Device Interface IPv6 address Device Interface IPv6 address
Router A GE2/1/1 1001::1/64 Router D GE2/1/1 4001::1/64
S3/1/1 1002::1/64 GE2/1/2 5001::1
/
64
Router B GE2/1/1 2001::1/64 S3/1/1 3001::2
/
64
S3/1/1 1002::2/64 Source 1 - 1001::2/64
S3/1/2 2002::1/64 Source 2 - 5001::2
/
64
Router C S3/1/1 2002::2
/
64 Receiver 1 - 2001::2
/
64
S3/1/2 3001::1/64 Receiver 2 - 4001::2/64
Loop0 6001::1
/
128
Configuration procedure
1. Enable IPv6 forwarding on each router, and configure the IPv6 address and prefix length for each
interface according to Figure 104. (Details not shown.)
2. Conf
igure OSPFv3 on the routers in the IPv6 BIDIR-PIM domain to ensure network-layer
reachability among them. (Details not shown.)
3. Enable IPv6 multicast routing, IPv6 PIM-SM, IPv6 BIDIR-PIM, and MLD:
# On Router A, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, and enable
IPv6 BIDIR-PIM.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] pim ipv6 sm
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface serial 3/1/1
[RouterA-Serial3/1/1] pim ipv6 sm
[RouterA-Serial3/1/1] quit
[RouterA] pim ipv6
[RouterA-pim6] bidir-pim enable
[RouterA-pim6] quit
# On Router B, enable IPv6 multicast routing, enable IPv6 PIM-SM on each interface, enable MLD
on interface GigabitEthernet 2/1/1, and enable IPv6 BIDIR-PIM.
IPv6 BIDIR-PIM
Source 1 Source 2
Host A
Receiver 1
Router A
S3/1/1
S3/1/1
S3/1/2 S3/1/1
S3/1/2
S3/1/1
GE2/1/1
GE2/1/1
G
E2/
1/1
GE2/1/2
Router D
Router C
Router B
Host B
Receiver 2
Loop0