R3303-HP HSR6800 Routers IP Multicast Configuration Guide

4
Ste
p
Command Descri
p
tion
3. Enter IPv6 MBGP multicast
address family view.
ipv6-family multicast N/A
4. Enable default route
redistribution into the IPv6
MBGP routing table.
default-route imported
Optional.
Default route redistribution is not
allowed by default.
5. Enable route redistribution
from another routing protocol.
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
Not enabled by default.
NOTE:
If the default-route imported command is not configured, using the import-route command cannot
redistribute any IGP default route.
Configuring IPv6 MBGP route summarization
To reduce the routing table size on medium and large BGP networks, you must configure route
summarization on IPv6 MBGP routers. BGP supports only manual summarization of IPv6 multicast routes.
To configure IPv6 MBGP route summarization:
Step Command Remarks
1. Enter system view
system-view
N/A
2. Enter BGP view
bgp as-number N/A
3. Enter IPv6 MBGP address family
view
ipv6-family multicast N/A
4. Configure manual route
summarization
aggregate ipv6-address prefix-length
[ as-set | attribute-policy
route-policy-name | detail-suppressed |
origin-policy route-policy-name |
suppress-policy route-policy-name ]*
Not configured by
default.
Advertising a default route to a peer or peer group
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view.
bgp as-number N/A
3. Enter IPv6 MBGP address
family view.
ipv6-family multicast N/A
4. Advertise a default route to an
IPv6 MBGP peer or peer
group.
peer { ipv6-group-name |
ipv6-address }
default-route-advertise
[ route-policy route-policy-name ]
Not advertised by default.