R3303-HP HSR6800 Routers IP Multicast Configuration Guide

17
Figure 106 Network diagram
Device Interface IP address Device Interface IP address
Source - 1002::100/64 Router C GE2/1/1 3002::1/64
Router
A
GE2/1/1 1002::1/64 S3/1/0 3001::1
/
64
POS5/1/0 1001::1/64 S3/1/1 2001::2
/
64
Router B POS5/1/0 1001::2/64 Router D S3/1/0 2002::2/64
S3/1/0 2001::1
/
64 S3/1/1 3001::2
/
64
S3/1/1 2002::1
/
64
Configuration procedure
1. Configure IPv6 addresses for router interfaces as shown in Figure 106 . (Details not shown.)
2. Configure OSPFv3. (Details not shown.)
3. Enable IPv6 multicast routing, IPv6 PIM-SM and MLD, and configure an IPv6 PIM-SM domain
border:
# Enable IPv6 multicast routing on Router A, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface gigabitethernet 2/1/1
[RouterA-GigabitEthernet2/1/1] pim ipv6 sm
[RouterA-GigabitEthernet2/1/1] quit
[RouterA] interface pos 5/1/0
[RouterA-Pos5/1/0] pim ipv6 sm
[RouterA-Pos5/1/0] quit
The configuration on Router B and Router D is similar to the configuration on Router A.
# Enable IPv6 multicast routing on Router C, enable IPv6 PIM-SM on each interface, and enable
MLD on the host-side interface GigabitEthernet 2/1/1.
<RouterC> system-view
[RouterC] multicast ipv6 routing-enable
[RouterC] interface serial 3/1/0
[RouterC-Serial3/1/0] pim ipv6 sm
[RouterC-Serial3/1/0] quit
[RouterC] interface serial 3/1/1
S
3
/
1
/
0
S
3
/
1
/
1
S
3
/
1
/
0
S
3
/
1
/
1
GE
2
/
1
/
1