R3303-HP HSR6800 Routers IP Multicast Configuration Guide

23
Configuration procedure
1. Assign an IP address and subnet mask to each interface according to Figure 108. (Details not
shown.)
2. On Router A, enable IP multicast routing, enable PIM-SM on each interface, and configure
interface Ethernet 1/2 as a C-BSR and C-RP.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim sm
[RouterA-Ethernet1/2] quit
[RouterA] pim
[RouterA-pim] c-bsr ethernet 1/2
[RouterA-pim] c-rp ethernet 1/2
3. On Router B, enable IP multicast routing, and enable PIM-SM on each interface.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] pim sm
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] pim sm
4. On Router C, enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP on
Ethernet 1/1.
<RouterC> system-view
[RouterC] multicast routing-enable
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] pim sm
[RouterC-Ethernet1/1] igmp enable
[RouterC-Ethernet1/1] quit
[RouterC] interface ethernet 1/2
[RouterC-Ethernet1/2] pim sm
5. Configure Router D in the same way as you configure Router C. (Details not shown.)
6. Configure Router E:
# Enable IGMP snooping globally.
<RouterE> system-view
[RouterE] igmp-snooping
[RouterE-igmp-snooping] quit
# Create VLAN 100, assign GigabitEthernet 2/0/1 through GigabitEthernet 2/0/4 to this VLAN,
and enable IGMP snooping and PIM snooping in the VLAN.
[RouterE] vlan 100
[RouterE-vlan100] port gigabitethernet 2/0/1 to gigabitethernet 2/0/4
[RouterE-vlan100] igmp-snooping enable
[RouterE-vlan100] pim-snooping enable
[RouterE-vlan100] quit