R3303-HP HSR6800 Routers IP Multicast Configuration Guide
54
Step Command Remarks
2. Configure a static multicast
route.
ip rpf-route-static [ vpn-instance
vpn-instance-name ]
source-address { mask |
mask-length } [ protocol
[ process-id ] ] [ route-policy
policy-name ] { rpf-nbr-address |
interface-type interface-number }
[ preference preference ] [ order
order-number ]
No static multicast route
configured by default.
When you configure a static
multicast route, you cannot specify
an RPF neighbor by providing the
type and number of the interface if
the interface is a Layer 3 Ethernet
interface, Layer 3 aggregate
interface, loopback interface,
Layer 3 RPR logical interface, or
VLAN interface. Instead, you can
specify such an RPF neighbor only
by its address.
3. Delete static multicast routes.
delete ip rpf-route-static
[ vpn-instance vpn-instance-name ]
Optional.
Configuring a multicast routing policy
You can configure the router to determine the RPF route based on the longest match principle. For more
information about RPF route selection, see "RPF check process."
B
y configuring per-source or per-source-and-group load splitting, you can optimize the traffic delivery
when multiple data flows are handled.
Configuring a multicast routing policy for the public network
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure the device to select
the RPF route based on the
longest match.
multicast longest-match
The route with the highest priority is
selected as the RPF route by
default.
3. Configure multicast load
splitting.
multicast load-splitting { source |
source-group }
Optional.
Disabled by default.
Configuring a multicast routing policy in a VPN instance
Ste
p
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VPN instance view.
ip vpn-instance
vpn-instance-name
N/A
3. Configure the device to
select the RPF route based on
the longest match.
multicast longest-match
The route with the highest priority is
selected as the RPF route by default.
4. Configure multicast load
splitting.
multicast load-splitting { source |
source-group }
Optional.
Disabled by default.