R3303-HP HSR6800 Routers IP Multicast Configuration Guide

67
Solution
1. Use the display multicast routing-table static command to view the configuration information of
static multicast routes to verify that the static multicast route has been correctly configured and that
the route entry exists in the multicast routing table.
2. Check the type of the next-hop interface of the static multicast route. If the interface is not a
point-to-point interface, be sure to specify the next hop address for the outgoing interface when
you configure the static multicast route.
3. Check that the static multicast route matches the specified routing protocol. If a protocol was
specified in static multicast route configuration, use the display ip routing-table command to verify
that an identical route was added by the protocol.
4. Check that the static multicast route matches the specified routing policy. If a routing policy was
specified when the static multicast route was configured, use the display route-policy command to
check the configured routing policy.