R3303-HP HSR6800 Routers IRF Command Reference

20
You must set up a dynamic link aggregation group that spans all IRF member devices between the IRF
fabric and the intermediate device. To enable dynamic link aggregation, configure the link-aggregation
mode dynamic command on the aggregate interface.
If the intermediate device is also in an IRF fabric, make sure the two IRF fabrics have different domain IDs
to avoid false detection of IRF splits.
When you use the mad enable command, the system prompts you to enter a domain ID. If you do not
want to change the current domain ID, press enter at the prompt.
Examples
# Enable LACP MAD on LACP-enabled Layer 2 dynamic aggregate interface 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] mad enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]: 1
The assigned domain ID is: 1
Info: MAD LACP only enable on dynamic aggregation interface.
# Enable LACP MAD on LACP-enabled Layer 3 dynamic aggregate interface 1.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1] mad enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]: 1
The assigned domain ID is: 1
Info: MAD LACP only enable on dynamic aggregation interface.
mad exclude interface
Use mad exclude interface to exclude a physical network port from being shut down when the IRF fabric
transitions to the Recovery state upon detection of a multi-active collision.
Use undo mad exclude interface to restore the default MAD action on a physical network port.
Syntax
mad exclude interface interface-type interface-number
undo mad exclude interface interface-type interface-number
Default
All physical network ports but the IRF physical ports and console port shut down when the IRF fabric
transitions to the Recovery state.
Views
System view
Default command level
3: Manage level
Parameters
interface-type interface-number: Specifies a port by its type and number.