R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

106
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] quit
[Sysname] port-group manual 2
[Sysname-port-group-manual-2] group-member GigabitEthernet 4/0/1 to GigabitEthernet
4/0/6
[Sysname-port-group-manual-2] port link-type hybrid
[Sysname-port-group-manual-2] port hybrid vlan 2 untagged
Configuring GigabitEthernet4/0/1... Done.
Configuring GigabitEthernet4/0/2... Done.
Configuring GigabitEthernet4/0/3... Done.
Configuring GigabitEthernet4/0/4... Done.
Configuring GigabitEthernet4/0/5... Done.
Configuring GigabitEthernet4/0/6... Done.
# Assign the hybrid Layer 2 aggregate interface Bridge-Aggregation 1 and its member ports to VLAN 2,
and configure them to send packets of VLAN 2 with tags removed.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type hybrid
[Sysname-Bridge-Aggregation1] port hybrid vlan 2 untagged
Please wait... Done.
Configuring GigabitEthernet4/0/1... Done.
Configuring GigabitEthernet4/0/2... Done.
Configuring GigabitEthernet4/0/3... Done.
The output shows that GigabitEthernet 4/0/1, GigabitEthernet 4/0/2, and GigabitEthernet 4/0/3 are
the member ports of the aggregation group corresponding to Bridge-Aggregation 1.
Related commands
port link-type
port link-type
Use port link-type to configure the link type of a port.
Use undo port link-type to restore the default link type of a port.
Syntax
port link-type { access | hybrid | trunk }
undo port link-type
Default
Any port is an access port.
Views
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level