R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

144
Default
The Join timer is set to 20 centiseconds.
Views
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default command level
2: System level
Parameters
timer-value: Specifies the Join timer (in centiseconds), which must be a multiple of 5 and range from twice
the Hold timer (inclusive) and half the Leave timer (inclusive).
Examples
# Set the GARP Join timer to 25 centiseconds, assuming that both the Hold timer and the Leave timer are
using the default.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/1
[Sysname-GigabitEthernet4/0/1] garp timer join 25
Related commands
• display garp timer
• garp timer hold
• garp timer leave
garp timer leave
Use garp timer leave to set the GARP Leave timer for an Ethernet port, Layer-2 aggregate interface, or all
ports in a port group.
Use undo garp timer leave to restore the default of the GARP Leave timer. This may fail if the default is
beyond the valid value range for the Leave timer.
Syntax
garp timer leave timer-value
undo garp timer leave
Default
The Leave timer is set to 60 centiseconds.
Views
Ethernet interface view, Layer-2 aggregate interface view, port group view
Default command level
2: System level
Parameters
timer-value: Specifies the Leave timer (in centiseconds), which must be a multiple of 5 and range from
twice the Join timer (exclusive) to the LeaveAll timer (exclusive).