R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

161
# Enable network-side QinQ on port group 1.
<Sysname> system-view
[Sysname] port-group manual 1
[Sysname-port-group-manual-1] group-member GigabitEthernet 4/0/1 to GigabitEthernet
4/0/6
[Sysname-port-group-manual-1] qinq enable uplink
remark customer-vlan-id
Use remark customer-vlan-id to add a CVLAN marking action to a traffic behavior.
Use undo remark customer-vlan-id to remove the action from the traffic behavior.
Syntax
remark customer-vlan-id vlan-id
undo remark customer-vlan-id
Views
Traffic behavior view
Default command level
2: System level
Parameters
vlan-id: Specifies a CVLAN ID in the range of 1 to 4094.
Examples
# Configure traffic behavior b1 to mark matching packets with CVLAN 111.
<Sysname> system-view
[Sysname] traffic behavior b1
[Sysname-behavior-b1] remark customer-vlan-id 111
remark service-vlan-id
Use remark service-vlan-id to add an SVLAN marking action to a traffic behavior.
Use undo remark service-vlan-id to remove the action from the traffic behavior.
Syntax
remark service-vlan-id vlan-id
undo remark service-vlan-id
Views
Traffic behavior view
Default command level
2: System level
Parameters
vlan-id: Specifies a SVLAN ID in the range of 1 to 4094.