R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

174

Views

Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view

Default command level

2: System level

Parameters

disable: Specifies the Disable mode. A port in this mode does not send or receive LLDPDUs.

rx: Specifies the Rx mode. A port in this mode only receives LLDPDUs.

tx: Specifies the Tx mode. A port in this mode only sends LLDPDUs.

txrx: Specifies the TxRx mode. A port in this mode sends and receives LLDPDUs.

Usage guidelines

The following matrix shows the command and router compatibility in Layer 2 Ethernet interface view:

Command HSR6802/HSR6804/HSR6808

lldp admin-status Yes on SAP modules operating in bridge mode

Examples

# Configure the LLDP operating mode as Rx for GigabitEthernet 4/0/1.

<Sysname> system-view

[Sysname] interface GigabitEthernet 4/0/1

[Sysname-GigabitEthernet4/0/1] lldp admin-status rx

lldp check-change-interval

Use lldp check-change-interval to enable LLDP polling and to set the polling interval.

Use undo lldp check-change-interval to restore the default.

Syntax

lldp check-change-interval interval

undo lldp check-change-interval

Default

LLDP polling is disabled.