R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

175
Command HSR6802/HSR6804/HSR6808
lldp
check-change-interval
Yes on SAP modules operating in bridge mode
Examples
# Enable LLDP polling on GigabitEthernet 4/0/1, setting the polling interval to 30 seconds.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/1
[Sysname-GigabitEthernet4/0/1] lldp check-change-interval 30
lldp compliance admin-status cdp
Use lldp compliance admin-status cdp to configure the operating mode of CDP-compatible LLDP on a
port or all ports in a port group.
Use undo lldp compliance admin-status cdp to restore the default.
Syntax
lldp compliance admin-status cdp { disable | txrx }
undo lldp compliance admin-status cdp
Default
CDP-compatible LLDP operates in disable mode.
Views
Layer 2 Ethernet interface view, Layer 3 Ethernet interface view, port group view
Default command level
2: System level
Parameters
disable: Specifies the disable mode, where CDP-compatible LLDP cannot receive or transmit CDP
packets.
txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Usage guidelines
For the router to work with Cisco IP phones, you must enable CDP-compatible LLDP globally, and then
configure CDP-compatible LLDP to operate in TxRx mode on the specified ports.
Examples
# Configure CDP-compatible LLDP to operate in TxRx mode on GigabitEthernet 4/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/1
[Sysname-GigabitEthernet4/0/1] lldp compliance admin-status cdp txrx
Related commands
lldp compliance cdp