R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

18
Field Description
Unknown-speed mode,
unknown-duplex mode
The interface speed and duplex mode are unknown.
PVID Port VLAN ID.
Last clearing of counters
Time when the reset counters interface command was last used to clear
the interface statistics.
Never indicates the reset counters interface command has never been
used on the interface since the device's startup.
Last 300 seconds input/output Average input/output rate over the last 300 seconds.
Input/Output (total) Statistics of all packets received/sent on the interface.
Input/Output (normal) Statistics of all normal packets received/sent on the interface.
Line protocol current state Link layer state of the interface.
Internet protocol processing
IP packet processing.
Disabled indicates that IP packets cannot be processed.
For an interface configured with an IP address, this field changes to
Internet Address is.
Output queue : (Urgent queuing :
Size/Length/Discards)
Output queue (current message number in the urgent queue/ maximum
number of messages allowed in the urgent queue/number of discarded
messages).
Output queue : (Protocol queuing :
Size/Length/Discards)
Output queue (current message number in the protocol queue/ maximum
number of messages allowed in the protocol queue/number of discarded
messages).
Output queue : (FIFO queuing :
Size/Length/Discards)
Output queue (current message number in the FIFO queue/ maximum
number of messages allowed in the FIFO queue/number of discarded
messages).
The brief information of interface(s)
under route mode
Brief information about Layer 3 interfaces.
The brief information of interface(s)
under bridge mode
Brief information about Layer 2 interfaces.
Link: ADM - administratively down;
Stby - standby
Link status:
• ADM—The interface has been administratively shut down. To recover
its physical layer state, perform the undo shutdown command.
• Stby—The interface is operating as a backup interface. The HSR6800
series does not support this status.
Speed or Duplex: (a)/A - auto; H -
half; F - full
If the speed of an interface is automatically negotiated, its speed attribute
includes the auto negotiation flag, letter a in parentheses.
If the duplex mode of an interface is automatically negotiated, its duplex
mode attribute includes the auto negotiation flag, letter a in parentheses
or a capital A. Letter H indicates the half duplex mode, and letter F
indicates the full duplex mode.
Type: A - access; T - trunk; H -
hybrid
Link type options for Ethernet interfaces.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is shown as UP, but its
link is an on-demand link or not present, its protocol attribute includes the
spoofing flag (an s in parentheses).