R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

31
Syntax
lacp system-priority system-priority
undo lacp system-priority
Default
The system LACP priority is 32768.
Views
System view
Default command level
2: System level
Parameters
system-priority: Specifies the LACP priority of the local system in the range of 0 to 65535. The smaller the
value, the higher the system LACP priority.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64
link-aggregation load-sharing mode
Use link-aggregation load-sharing mode to configure the global or group-specific link-aggregation load
sharing criteria.
Use undo link-aggregation load-sharing mode to restore the default setting.
Syntax
link-aggregation load-sharing mode { { destination-ip | destination-mac | source-ip | source-mac } *
| per-packet }
undo link-aggregation load-sharing mode
Default
The default of this command varies with device models.
Views
System view, Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default command level
2: System level
Parameters
destination-ip: Performs load sharing in link aggregation groups based on destination IP address.
destination-mac: Performs load sharing in link aggregation groups based on destination MAC address.
source-ip: Performs load sharing in link aggregation groups based on source IP address.
source-mac: Performs load sharing in link aggregation groups based on source MAC address.
per-packet: Performs per-packet load sharing in link aggregation groups. This keyword is not supported
on Layer 2 aggregate interfaces.