R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

73
force-true: Specifies the point-to-point link type.
Usage guidelines
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in port group view, the setting takes effect on all member ports in the port group.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
When connecting to a non-point-to-point link, a port is incapable of rapid state transition.
You can configure the link type as point-to-point for a Layer 2 aggregate interface or a port that operates
in full duplex mode. HP recommends that you use the default setting to let the device automatically detect
the port link type.
The stp point-to-point force-false or stp point-to-point force-true command configured on a port in MSTP
mode takes effect on all MSTIs.
If the physical link to which the port connects is not a point-to-point link but you set it to be one, the
configuration might bring a temporary loop.
Examples
# Configure the link connecting GigabitEthernet 4/0/3 as a point-to-point link.
<Sysname> system-view
[Sysname] interface GigabitEthernet 4/0/3
[Sysname-GigabitEthernet4/0/3] stp point-to-point force-true
Related commands
display stp
stp port priority
Use stp port priority to set the priority of the ports.
Use undo stp port priority to restore the default.
Syntax
stp [ instance instance-id ] port priority priority
undo stp [ instance instance-id ] port priority
Default
The port priority is 128.
Views
Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
instance instance-id: Sets the priority of the ports in a particular MSTI. The value range for this argument
is 0 to 31. The value 0 represents the CIST.