R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

86
BPDU tunneling configuration commands
The commands in this chapter are supported on SAP interface modules that are operating in bridge
mode.
bpdu-tunnel dot1q
Use bpdu-tunnel dot1q to enable BPDU tunneling for a protocol on the ports.
Use undo bpdu-tunnel dot1q to disable BPDU tunneling for a protocol on the ports.
Syntax
In Layer 2 Ethernet interface view or port group view:
bpdu-tunnel dot1q { cdp | dldp | eoam | gvrp | hgmp | lacp | lldp | pagp | pvst | stp | udld | vtp }
undo bpdu-tunnel dot1q { cdp | dldp | eoam | gvrp | hgmp | lacp | lldp | pagp | pvst | stp | udld
| vtp }
In Layer 2 aggregate interface view:
bpdu-tunnel dot1q { cdp | gvrp | hgmp | pvst | stp | vtp }
undo bpdu-tunnel dot1q { cdp | gvrp | hgmp | pvst | stp | vtp }
Default
BPDU tunneling for any protocol is disabled.
Views
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
cdp: Specifies CDP.
dldp: Specifies DLDP.
eoam: Specifies EOAM.
gvrp: Specifies GVRP.
hgmp: Specifies HGMP.
lacp: Specifies LACP.
lldp: Specifies LLDP.
pagp: Specifies PAGP.
pvst: Specifies PVST.
stp: Specifies STP.
udld: Specifies UDLD.
vtp: Specifies VTP.