R3303-HP HSR6800 Routers Layer 2 - LAN Switching Command Reference

89
VLAN configuration commands
The commands in this chapter are supported on SAP modules that are operating in bridge mode.
Basic VLAN configuration commands
bandwidth
Use bandwidth to set the expected bandwidth for a VLAN-interface.
Use undo bandwidth to cancel the configuration.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
VLAN-interface view
Default command level
2: System level
Parameters
bandwidth-value: Sets the expected bandwidth in the range of 1 to 4,294,967,295 kbps.
Usage guidelines
You can obtain the expected bandwidth of an interface by querying the ifspeed value of the MIB node
with third-party software.
The expected bandwidth is used by network management systems for monitoring bandwidth, but does
not affect the actual bandwidth of the interface.
Examples
# Set the expected bandwidth to 10,000 kbps for interface VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] bandwidth 10000
description
Use description to change the description of the VLAN or VLAN-interface.
Use undo description to restore the default.
Syntax
description text
undo description