R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

92
Actions Access Trunk H
y
brid
Incoming
tagged frame
• Receives the frame if
its VLAN ID is the
same as the PVID.
• Drops the frame if its
VLAN ID is different
from the PVID.
• Receives the frame if its VLAN is permitted on the port.
• Drops the frame if its VLAN is not permitted on the port.
Outgoing
frames
Removes the VLAN tag
and sends the frame.
• Removes the tag and sends
the frame if the frame carries
the PVID tag and the port
belongs to the PVID.
• Sends the frame without
removing the tag if its VLAN
is carried on the port but is
different from the PVID.
Sends the frame if its VLAN is
permitted on the port. The frame
is sent with the VLAN tag
removed or intact depending on
your configuration with the port
hybrid vlan command. This is
true of the PVID.
Assigning an access port to a VLAN
You can assign an access port to a VLAN in VLAN view or interface view. Before you assign an access
port to a VLAN, create the VLAN.
In VLAN view, you can assign only Layer 2 Ethernet interfaces to the VLAN.
To assign one or multiple access ports to a VLAN in VLAN view:
Ste
p
Command Remarks
1. Enter system view
system-view N/A
2. Enter VLAN view
vlan vlan-id N/A
3. Assign one or a group of
access ports to the VLAN
port interface-list By default, all ports belong to VLAN 1.
To assign an access port to a VLAN in interface view:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A