R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

113
Ste
p
Command Remarks
4. Enable local proxy ARP.
5. Enable local proxy ND.
• Enable local proxy ARP:
local-proxy-arp enable
• Enable local proxy ND:
local-proxy-nd enable
Use one of the commands.
By default, local proxy ARP and
local proxy ND are disabled.
For more information about local
proxy ARP and proxy ND
functions, see Layer 3—IP Services
Configuration Guide. For more
information about local-proxy-arp
enable and local-proxy-nd enable
commands, see Layer 3—IP
Services Command Reference.
Displaying and maintaining super VLAN
Task Command Remarks
Display mapping between a super
VLAN and its sub-VLANs.
display supervlan [ supervlan-id ] [ | { begin |
exclude | include } regular-expression ]
Available in any
view.
Super VLAN configuration example
Network requirements
As shown in Figure 41:
• Create super VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.
• Create sub-VLANs VLAN 2, VLAN 3, and VLAN 5.
• Assign GigabitEthernet 4/0/1 and GigabitEthernet 4/0/2 to VLAN 2, GigabitEthernet 4/0/3
and GigabitEthernet 4/0/4 to VLAN 3, and GigabitEthernet 4/0/5 and GigabitEthernet 4/0/6
to VLAN 5.
• The sub-VLANs are isolated at Layer 2 but connected at Layer 3.
Figure 41 Network diagram
Configuration procedure
# Create VLAN 10, and configure its VLAN interface IP address as 10.0.0.1/24.