R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

124
[RouterA-GigabitEthernet4/0/2] voice vlan mode auto
[RouterA-GigabitEthernet4/0/2] voice vlan 3 enable
Verifying the configuration
# Display OUI addresses, OUI address masks, and description strings.
<RouterA> display voice vlan oui
Oui Address Mask Description
0001-e300-0000 ffff-ff00-0000 Siemens phone
0003-6b00-0000 ffff-ff00-0000 Cisco phone
0004-0d00-0000 ffff-ff00-0000 Avaya phone
0011-1100-0000 ffff-ff00-0000 IP phone A
0011-2200-0000 ffff-ff00-0000 IP phone B
0060-b900-0000 ffff-ff00-0000 Philips/NEC phone
00d0-1e00-0000 ffff-ff00-0000 Pingtel phone
00e0-7500-0000 ffff-ff00-0000 Polycom phone
00e0-bb00-0000 ffff-ff00-0000 3com phone
# Display the states of voice VLANs.
<RouterA> display voice vlan state
Maximum of Voice VLANs: 128
Current Voice VLANs: 2
Voice VLAN security mode: Security
Voice VLAN aging time: 30 minutes
Voice VLAN enabled port and its mode:
PORT VLAN MODE COS DSCP
---------------------------------------------------------------------------
GigabitEthernet4/0/1 2 AUTO 6 46
GigabitEthernet4/0/2 3 AUTO 6 46
Manual voice VLAN assignment mode configuration example
Network requirements
As shown in Figure 45, the IP phones send untagged voice traffic.
Create VLAN 2 and configure it as a voice VLAN that permits only voice traffic to pass through.
Configure GigabitEthernet 4/0/1 as a hybrid port, and configure GigabitEthernet 4/0/1 to operate in
manual voice VLAN assignment mode. Configure GigabitEthernet 4/0/1 to allow voice traffic with an
OUI address of 0011-2200-0000, a mask of ffff-ff00-0000, and a description string of test to be
forwarded in the voice VLAN.