R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

135
[RouterA] interface GigabitEthernet 3/0/1
[RouterA-GigabitEthernet3/0/1] port link-type trunk
[RouterA-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable GVRP on trunk port GigabitEthernet 3/0/1.
[RouterA-GigabitEthernet3/0/1] gvrp
[RouterA-GigabitEthernet3/0/1] quit
# Create VLAN 2 (a static VLAN).
[RouterA] vlan 2
[RouterA-vlan2] quit
2. Configure Router B:
# Enable GVRP globally.
<RouterB> system-view
[RouterB] gvrp
# Configure port GigabitEthernet 3/0/1 as a trunk port, and assign it to all VLANs.
[RouterB] interface GigabitEthernet 3/0/1
[RouterB-GigabitEthernet3/0/1] port link-type trunk
[RouterB-GigabitEthernet3/0/1] port trunk permit vlan all
# Enable GVRP on trunk port GigabitEthernet 3/0/1.
[RouterB-GigabitEthernet3/0/1] gvrp
[RouterB-GigabitEthernet3/0/1] quit
# Create VLAN 3 (a static VLAN).
[RouterB] vlan 3
[RouterB-vlan3] quit
Verifying the configuration:
Use the display gvrp local-vlan command to display the local VLAN information that GVRP
maintains on ports. For example:
# Display the local VLAN information that GVRP maintains on port GigabitEthernet 3/0/1 of
Router A.
[RouterA] display gvrp local-vlan interface GigabitEthernet 3/0/1
Following VLANs exist in GVRP local database:
1(default),2-3
The output shows that information about VLAN 1, static VLAN information about VLAN 2 on the
local router, and dynamic VLAN information about VLAN 3 on Router B are all registered through
GVRP.
# Display the local VLAN information maintained by GVRP on port GigabitEthernet 3/0/1 of
Router B.
[RouterB] display gvrp local-vlan interface GigabitEthernet 3/0/1
Following VLANs exist in GVRP local database:
1(default),2-3
The output shows that information about VLAN 1, static VLAN information about VLAN 3 on the
local router, and dynamic VLAN information about VLAN 2 on Router A are all registered through
GVRP.