R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

153
Figure 55 Network diagram
Configuration procedure
This example assumes that devices in the service provider network have been configured to allow QinQ
packets to pass through.
1. Configure PE 1:
a. Configure GigabitEthernet 4/0/1:
# Configure GigabitEthernet 4/0/1 as a trunk port, and assign it to VLANs 10 through 50.
<PE1> system-view
[PE1] interface GigabitEthernet 4/0/1
[PE1-GigabitEthernet4/0/1] port link-type trunk
[PE1-GigabitEthernet4/0/1] port trunk permit vlan 10 to 50
# Enable basic QinQ on the port.
[PE1-GigabitEthernet4/0/1] qinq enable
# Configure the port to transparently transmit frames from VLANs 10 through 50.
[PE1-GigabitEthernet4/0/1] qinq transparent-vlan 10 to 50
[PE1-GigabitEthernet4/0/1] quit
b. Configure GigabitEthernet 4/0/2:
# Configure GigabitEthernet 4/0/2 as a trunk port, and assign it to VLANs 10 through 50.
[PE1] interface GigabitEthernet 4/0/2
[PE1-GigabitEthernet4/0/2] port link-type trunk
[PE1-GigabitEthernet4/0/2] port trunk permit vlan 10 to 50
# Set the TPID value in the outer VLAN tag to 0x8200 on the port.
[PE1-GigabitEthernet4/0/2] qinq ethernet-type service-tag 8200
[PE1-GigabitEthernet4/0/2] quit
2. Configure PE 2:
a. Configure GigabitEthernet 4/0/1:
# Configure GigabitEthernet 4/0/1 as a trunk port, and assign it to VLANs 10 through 50.
<PE2> system-view
[PE2] interface GigabitEthernet 4/0/1
[PE2-GigabitEthernet4/0/1] port link-type trunk
[PE2-GigabitEthernet4/0/1] port trunk permit vlan 10 to 50