R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

182
Ste
p
Command Remarks
2. Enter Ethernet interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Ethernet port group view:
port-group manual
port-group-name
N/A
3. Configure the link type of the
port.
• Configure the port as a trunk
port:
port link-type trunk
• Configure the port as a hybrid
port:
port link-type hybrid
Use one of the commands.
The default link type of an Ethernet
port is access.
4. Assign the port to all
CVLANs.
• As a trunk port:
port trunk permit vlan { vlan-list
| all }
• As a hybrid port:
port hybrid vlan vlan-list
tagged
Use one of the commands.
By default:
• A trunk port is assigned to only
VLAN 1.
• A hybrid port is an untagged
member of VLAN 1.
5. Enable basic QinQ.
qinq enable By default, basic QinQ is disabled.
6. Apply the uplink policy to
incoming traffic.
qos apply policy policy-name
inbound
N/A
7. Apply the downlink policy to
outgoing traffic.
qos apply policy policy-name
outbound
N/A
Configuring the network-side port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Ethernet interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Ethernet port group view:
port-group manual
port-group-name
• Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
N/A