R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

188
Configuring the customer-side port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Ethernet port group view:
port-group manual
port-group-name
N/A
3. Configure the port as a hybrid
port.
port link-type hybrid
The default link type of an Ethernet
port is access.
4. Assign the port to the SVLANs
as an untagged member.
port hybrid vlan vlan-list untagged
By default, a hybrid port is an
untagged member of VLAN 1.
5. Enable basic QinQ.
qinq enable
By default, basic QinQ is disabled
on all ports.
6. Apply the uplink policy to
incoming traffic.
qos apply policy policy-name
inbound
N/A
Configuring the network-side port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Ethernet port group view:
port-group manual
port-group-name
• Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
N/A
3. Configure the link type of the
port.
• Configure the port as a trunk
port:
port link-type trunk
• Configure the port as a hybrid
port:
port link-type hybrid
The default link type of an Ethernet
port is access.