R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

193
Ste
p
Command Remarks
2. Enter interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Ethernet port group view:
port-group manual
port-group-name
N/A
3. Configure the link type of the
port.
• Configure the port as a trunk
port:
port link-type trunk
• Configure the port as a hybrid
port:
port link-type hybrid
Use one of the commands.
The default link type of an Ethernet
port is access.
4. Assign the port to all
CVLANs.
• As a trunk port:
port trunk permit vlan { vlan-list
| all }
• As a hybrid port:
port hybrid vlan vlan-list
tagged
Use one of the commands.
By default:
• A trunk port is assigned to only
VLAN 1.
• A hybrid port is an untagged
member of VLAN 1.
5. Apply the uplink policy
configured for the
customer-side port to
incoming traffic.
qos apply policy policy-name
inbound
N/A
6. Apply the downlink policy
configured for the
customer-side port to outgoing
traffic.
qos apply policy policy-name
outbound
N/A
Configuring the network-side port
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
• Enter Layer 2 Ethernet interface
view:
interface interface-type
interface-number
• Ethernet port group view:
port-group manual
port-group-name
N/A
3. Configure the link type of the
port.
• Configure the port as a trunk
port:
port link-type trunk
• Configure the port as a hybrid
port:
port link-type hybrid
The default link type of an Ethernet
port is access.