R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

218
Transmit delay : 2s
Trap interval : 5s
Fast start times : 3
Port 1 [GigabitEthernet4/0/1]:
Port status of LLDP : Enable
Admin status : Rx_Only
Trap flag : No
Polling interval : 0s
Number of neighbors: 1
Number of MED neighbors : 1
Number of CDP neighbors : 0
Number of sent optional TLV : 0
Number of received unknown TLV : 0
Port 2 [GigabitEthernet4/0/2]:
Port status of LLDP : Enable
Admin status : Rx_Only
Trap flag : No
Polling interval : 0s
Number of neighbors: 1
Number of MED neighbors : 0
Number of CDP neighbors : 0
Number of sent optional TLV : 0
Number of received unknown TLV : 3
As shown in the sample output, GigabitEthernet 4/0/1 of Router A connects to an MED device,
and GigabitEthernet 4/0/2 of Router A connects to a non-MED device. Both ports operate in Rx
mode, and they only receive LLDPDUs.
# Remove the link between Router A and Router B and then display the global LLDP status and port
LLDP status on Router A.
[RouterA] display lldp status
Global status of LLDP: Enable
The current number of LLDP neighbors: 1
The current number of CDP neighbors: 0
LLDP neighbor information last changed time: 0 days,0 hours,5 minutes,20 seconds
Transmit interval : 30s
Hold multiplier : 4
Reinit delay : 2s
Transmit delay : 2s
Trap interval : 5s
Fast start times : 3
Port 1 [GigabitEthernet4/0/1]:
Port status of LLDP : Enable
Admin status : Rx_Only
Trap flag : No