R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

13
To configure a Layer 2 static aggregation group:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view.
interface bridge-aggregation
interface-number
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
3. Exit to system view.
quit N/A
4. Assign a Layer 2 Ethernet
interface to the aggregation
group.
a. interface interface-type
interface-number
b. port link-aggregation
group number
Repeat these two sub-steps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.
5. Assign the port an
aggregation priority.
link-aggregation port-priority
port-priority
Optional.
By default, the aggregation priority
of a port is 32768.
When the number of ports eligible
for Selected ports exceeds the
maximum number of Selected ports
allowed in a static aggregation
group, changing the aggregation
priority of a port might affect the
aggregation state of the ports in
the static aggregation group.
Configuring a Layer 3 static aggregation group
To guarantee a successful static aggregation, make sure the ports at both ends of each link are in the
same aggregation state.
To configure a Layer 3 static aggregation group:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Create a Layer 3 aggregate
interface and enter Layer 3
aggregate interface view.
interface route-aggregation
interface-number
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group with the
same number.
3. Exit to system view.
quit N/A
4. Assign a Layer 3 Ethernet
interface to the aggregation
group.
a. interface interface-type
interface-number
b. port link-aggregation
group number
Repeat these two sub-steps to
assign more Layer 3 Ethernet
interfaces to the aggregation
group.