R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

22
Task Command Remarks
Display detailed link aggregation
information for link aggregation
member ports.
display link-aggregation member-port
[ interface-list ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view.
Display summary information
about all aggregation groups.
display link-aggregation summary [ | { begin |
exclude | include } regular-expression ]
Available in any
view.
Display detailed information about
a specific or all aggregation
groups.
display link-aggregation verbose
[ { bridge-aggregation | route-aggregation }
[ interface-number ] ] [ | { begin | exclude |
include } regular-expression ]
Available in any
view.
Clear LACP statistics for a specific
or all link aggregation member
ports.
reset lacp statistics [ interface interface-list ]
Available in user
view.
Clear statistics for a specific or all
aggregate interfaces.
reset counters interface [ { bridge-aggregation |
route-aggregation } [ interface-number ] ]
Available in user
view.
Ethernet link aggregation configuration examples
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
"Configuration classes") a
s the reference port (see "Reference port") can operate as Selected ports.
Make sure all member ports have the same port attributes and class-two configurations as the reference
port. The other settings only need to be configured on the aggregate interface, not on the member ports.
Layer 2 static aggregation configuration example
Network requirements
Configure a Layer 2 static aggregation group on Router A and Router B (in Figure 7). Enable VLAN 10
at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at one
end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on the source and
destination MAC addresses.
Figure 7 Network diagram