R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing

Actor System ID: 0x8000, 000f-e2ff-0001

AGG AGG Partner ID Select Unselect Share

Interface Mode Ports Ports Type

-------------------------------------------------------------------------------

BAGG1 S none 3 0 Shar

The output shows that link aggregation group 1 is a load-shared Layer 2 static aggregation group

and it contains three Selected ports.

# Display the global link-aggregation load-sharing criteria on Router A.

[RouterA] display link-aggregation load-sharing mode

Link-Aggregation Load-Sharing Mode:

destination-mac address, source-mac address

The output shows that all link aggregation groups created on the device perform load sharing

based on source and destination MAC addresses.

Layer 2 dynamic aggregation configuration example

Network requirements

Configure a Layer 2 dynamic aggregation group on Router A and Router B (in Figure 8). Enable VLAN

10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20 at one

end to communicate with VLAN 20 at the other end.

Enable traffic to be load-shared across aggregation group member ports based on source and

destination MAC addresses.

Figure 8 Network diagram

Configuration procedure

1. Configure Router A:

# Create VLAN 10, and assign the port GigabitEthernet 4/0/4 to VLAN 10.

<RouterA> system-view

[RouterA] vlan 10

[RouterA-vlan10] port GigabitEthernet 4/0/4