R3303-HP HSR6800 Routers Layer 2 - LAN Switching Configuration Guide

BAGG1 D 0x8000, 000f-e2ff-0002 3 0 Shar

The output shows that link aggregation group 1 is a load-shared Layer 2 dynamic aggregation

group, and it contains three Selected ports.

# Display the global link-aggregation load-sharing criteria on Router A.

[RouterA] display link-aggregation load-sharing mode

Link-Aggregation Load-Sharing Mode:

destination-mac address, source-mac address

The output shows that all link aggregation groups created on the device perform load sharing

based on source and destination MAC addresses.

Layer 2 aggregation load sharing configuration example

Network requirements

Configure two Layer 2 static aggregation groups (1 and 2) on Router A and Router B (in Figure 9), and

enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and

VLAN 20 at one end to communicate with VLAN 20 at the other end.

Configure the load sharing criterion for link aggregation group 1 as the source MAC addresses of

packets and the load sharing criterion for link aggregation group 2 as the destination MAC addresses

of packets to enable traffic to be load-shared across aggregation group member ports.

Figure 9 Network diagram

Configuration procedure

1. Configure Router A:

# Create VLAN 10, and assign the port GigabitEthernet 4/0/5 to VLAN 10.

<RouterA> system-view

[RouterA] vlan 10

[RouterA-vlan10] port GigabitEthernet 4/0/5

[RouterA-vlan10] quit

# Create VLAN 20, and assign the port GigabitEthernet 4/0/6 to VLAN 20.

<RouterA> system-view

[RouterA] vlan 20

[RouterA-vlan20] port GigabitEthernet 4/0/6