R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

133
Examples
# Enable InARP at all PVCs of the frame relay interface Serial 2/0/0.
<Sysname> system-view
[Sysname] interface serial 2/0/0
[Sysname-Serial2/0/0] fr inarp
fr interface-type
Use fr interface-type to set the frame relay interface type.
Use undo fr interface-type to restore the default frame relay interface type.
Syntax
fr interface-type { dce | dte | nni }
undo fr interface-type
Default
The frame relay interface type is DTE.
Views
Interface view
Default command level
2: System level
Parameters
dce: Sets the frame relay interface type to DCE.
dte: Sets the frame relay interface type to DTE.
nni: Sets the frame relay interface type to NNI.
Examples
# Set the type of the frame relay interface Serial 2/0/0 to DCE.
<Sysname> system-view
[Sysname] interface serial2/0/0
[Sysname-Serial2/0/0] fr interface-type dce
fr lmi n391dte
Use fr lmi n391dte to configure the full link status polling interval at the DTE side.
Use undo fr lmi n391dte to restore the default.
Syntax
fr lmi n391dte n391-value
undo fr lmi n391dte
Default
The full link status polling interval is 6.