R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

138
Views
Interface view
Default command level
2: System level
Parameters
t392-value: Sets the DCE-side T392 timer, in seconds. The value range is 5 to 30.
Usage guidelines
The DCE-side T392 timer defines the maximum time that the DCE waits for a Status-Enquiry message.
The DCE-side T392 timer must be greater than the DTE-side T391 timer (set by the timer hold command).
Examples
# Set frame relay interface Serial 2/0/0 to operate in DCE mode, and set T392 to 10 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0/0
[Sysname-Serial2/0/0] link-protocol fr
[Sysname-Serial2/0/0] fr interface-type dce
[Sysname-Serial2/0/0] fr lmi t392dce 10
fr lmi type
Use fr lmi type to configure the frame relay LMI protocol type.
Use undo fr lmi type to restore the default.
Syntax
fr lmi type { ansi | nonstandard | q933a }
undo fr lmi type
Default
The LMI protocol type is q933a.
Views
Interface view
Default command level
2: System level
Parameters
ansi: Standard LMI protocol of ANSI T1.617 Appendix D.
nonstandard: Nonstandard compatible LMI protocol.
q933a: Standard LMI protocol of Q.933 Appendix A.
Usage guidelines
LMI protocol maintains frame relay protocol PVC table, including notifying PVC increasing, detecting
PVC deleting, monitoring PVC status changing and authenticating link integrity. The system usually
supports three standard LMI protocols ITU-T Q.933 Appendix A, ANSI T1.617 Appendix D, and
nonstandard-compatible LMI protocol.