R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

143
Parameters
interface-number: MFR interface number.
Usage guidelines
Before performing this command, make sure the specified MFR interface already exists. A maximum of
16 physical interfaces can be bundled onto an MFR interface.
To delete a physical interface from an MFR interface, use the link-protocol command on the interface to
configure a link layer protocol except MFR.
After MFR encapsulation is enabled on a physical interface, the interface belongs to an MFR interface
and cannot be configured with any FR-related commands except MFR. In addition, the queuing type on
the interface can be configured as first in first out (FIFO) only. If the interface uses another queuing type
before you configure the MFR encapsulation, the interface is forced to use FIFO after you configure the
MFR encapsulation.
Examples
# Configure Serial 2/0/0 as a bundle link and add it onto the Frame Relay bundle interface MFR4/0/0.
<Sysname> system-view
[Sysname] interface serial 2/0/0
[Sysname-Serial2/0/0] link-protocol fr mfr 4/0/0
reset fr inarp
Use reset fr inarp to clear the address mapping established by inverse ARP.
Syntax
reset fr inarp
Views
User view
Default command level
2: System level
Usage guidelines
In some special cases, for example, when the network topology changes, the dynamic address maps
originally established will become invalid. You must establish them again. You can use this command to
clear all dynamic address maps.
Examples
# Clear all frame relay dynamic address maps.
<Sysname> reset fr inarp
Related commands
fr inarp
reset fr pvc
Use reset fr pvc to clear the statistics on a PVC.