R3303-HP HSR6800 Routers Layer 2 - WAN Command Reference

145
Syntax
timer hold seconds retries
undo timer hold
Default
The T391 parameter is 10 seconds, and the times for which the DTE sends status enquiry messages is 5.
Views
Interface view
Default command level
2: System level
Parameters
seconds: Sets the value of T391 parameter at DTE side, in the range of 0 to 32767 in seconds. 0 indicates
that the LMI protocol is disabled.
retries: Specifies the times for which the DTE sends status enquiry messages, in the range of 1 to 255.
Usage guidelines
The parameter is a time variable that defines the interval at which the DTE sends Status-Enquiry
messages.
Examples
# Configure that frame relay interface Serial 2/0/0 to operate in DTE mode. Set the value of T391
parameter to 15 seconds, and set the times for which the DTE sends status enquiry messages to 10.
<Sysname> system-view
[Sysname] interface serial 2/0/0
[Sysname-Serial2/0/0] link-protocol fr
[Sysname-Serial2/0/0] fr interface-type dte
[Sysname-Serial2/0/0] timer hold 15 10
Related commands
fr lmi t392dce
MFR configuration commands
bandwidth
Use bandwidth to set the intended bandwidth for an MFR interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Views
MFR interface view